TF Type Flanges
Model TF flanges are produced from precisely the same high-strength cast iron as the S flanges, but are made to accommodate the worldwide standard Taper Lock bushing for straightforward installation and elimination
TF Style flanges permit for mounting the bushing over the front (hub) side of the flange
TF flanges can be found in sizes 6 through 16 and can be employed with any type of sleeve as pictured on web page SF-5
TR Variety Flanges
TR flanges are very similar towards the TF fashion, but enable to the Taper Lock Bushing to be mounted and eliminated from
the reverse or serration side on the flange
The restricted torque ratings from the Taper Lock Bushings permit TR flanges to only be utilised with EPDM or Neoprene sleeves
Unique bushing sizes are utilised, so they have different maximum bores than the TF flanges
Sizes 6 as a result of 16 are available
Taper-Lock Bushings
The sector standard taper lock bushing is a split style allowing a compression fit of the flange for the shaft without set screws
The basic layout tends to make the installation and removal simple while the 8° taper grips tight and gives exceptional concentricity
A Reduced level of stock is usually accomplished on account of the numerous other energy transmission parts that use Taper Lock Bushings including: sheaves, sprockets, and pulleys
won’t provide the Taper-Lock Bushings themselves as they are widely available from other manufacturers