C Variety Flex-Flex Couplings
The C Sort coupling includes two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Variety coupling include one particular flex hub, a single rigid hub, one sleeve, a single accessory kit consisting of 
seals and snap rings.
Attributes
Very simple and reasonably priced variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Out there as vertical and horizontal couplings
Broad assortment of special variations for instance full-flex, flex-rigid mill motor
Typical configurations can be found from the shelf
Ordering Facts
Application: Driver and Driven.
Kind and size of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Facts
Puller Holes are typical on sizes four as a result of twelve.
Puller Holes are available for sizes 7/8 by 3.5 at an additional charge.
The BSE (distance Amongst Shaft Ends) may possibly fluctuate in between G and G1.
Interference bores with no set screws are common except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Section.
Bigger sizes can be found, please seek the advice of Technical Assistance.
